Wood Processing Activities
The Timber manufacturing process generally follows these steps:
Our Kiln-dry uses a steam heating system, which is obtained from a boiler, flowed into a heating pipe, and then heat is transferred to the circulating air. The remaining wood waste is used as fuel to produce steam in the boiler
alignment of the wood surface
After the wood dried, it goes to the next production step, which is processing the wood in the milling machine to get the geometric alignment after the drying process completed. In the drying stage, it is possible to be bend, curve, and reduce the geometric dimensions. This is the natural process that occurs during the drying. Wood surface alignment must be carried out by factory before entering the next stage
In this step, the cutting machine directly straightens the length and plane of the workpiece. After that, the final step is to provide a profile bar in the form of a joint.
Tenon & mortise, cross lap, and lap joint is a wood connecting technique that we often use in building construction products. This connection is very strong, apart from being intertwined with each other
At the factory site, the initial assembly of the wooden house kit made. Each wooden kit installed and dimensions checked, where it is all parallel and symmetrical. The quality and strength of wood joints also examined. After the wooden house has passed the quality inspection, it carries out to the packaging stage.
Packing in the container
When all components of wooden houses loaded into containers. Some consumers intend to get more space in the container without using a pallet, so we will assist them to fit it in the container.